Посыпался винт? Гляньте на СМАРТМожно еще поюзать или уже менять? Насколько вероятно, что начнет лавинно обсыпаться?
Блин, не такой старый этот ноут
Код: Виділити все
smartctl 6.4 2014-10-07 r4002 [x86_64-linux-4.2.0-23-generic] (local build)
Copyright (C) 2002-14, Bruce Allen, Christian Franke, http://www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Momentus 5400.6
Device Model: ST9500325AS
Serial Number: S2WJAYSA
LU WWN Device Id: 5 000c50 050e50dba
Firmware Version: 0005HPM1
User Capacity: 500 107 862 016 bytes [500 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 5400 rpm
Form Factor: 2.5 inches
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 2.6, 3.0 Gb/s
Local Time is: Fri Jan 22 21:40:16 2016 EET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 137) minutes.
SCT capabilities: (0x103f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 117 099 006 Pre-fail Always - 141410193
3 Spin_Up_Time 0x0002 099 099 000 Old_age Always - 0
4 Start_Stop_Count 0x0033 098 098 000 Pre-fail Always - 2682
5 Reallocated_Sector_Ct 0x0033 098 098 036 Pre-fail Always - 54
7 Seek_Error_Rate 0x000f 081 060 030 Pre-fail Always - 141318988
9 Power_On_Hours 0x0032 088 088 000 Old_age Always - 10851
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0033 098 098 020 Pre-fail Always - 2468
183 Runtime_Bad_Block 0x0032 100 253 000 Old_age Always - 0
184 End-to-End_Error 0x0033 100 100 097 Pre-fail Always - 0
187 Reported_Uncorrect 0x0032 029 029 000 Old_age Always - 71
188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 057 048 045 Old_age Always - 43 (Min/Max 34/44)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 224
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 48
193 Load_Cycle_Count 0x0032 081 081 000 Old_age Always - 39175
194 Temperature_Celsius 0x0022 043 052 000 Old_age Always - 43 (0 8 0 0 0)
195 Hardware_ECC_Recovered 0x001a 050 045 000 Old_age Always - 141410193
196 Reallocated_Event_Count 0x0033 098 098 036 Pre-fail Always - 54
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 4
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 68 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 68 occurred at disk power-on lifetime: 10720 hours (446 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 02:50:36.466 READ FPDMA QUEUED
61 00 a0 e0 a4 54 4e 00 02:50:36.466 WRITE FPDMA QUEUED
60 00 10 50 25 d2 45 00 02:50:36.466 READ FPDMA QUEUED
61 00 08 68 39 c6 42 00 02:50:36.465 WRITE FPDMA QUEUED
ea 00 00 00 00 00 a0 00 02:50:36.465 FLUSH CACHE EXT
Error 67 occurred at disk power-on lifetime: 10720 hours (446 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 02:50:33.990 READ FPDMA QUEUED
60 00 20 00 25 d2 45 00 02:50:33.990 READ FPDMA QUEUED
61 00 08 ff ff ff 4f 00 02:50:33.989 WRITE FPDMA QUEUED
ea 00 00 00 00 00 a0 00 02:50:33.885 FLUSH CACHE EXT
60 00 10 f0 24 d2 45 00 02:50:33.883 READ FPDMA QUEUED
Error 66 occurred at disk power-on lifetime: 10720 hours (446 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 02:50:31.418 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 02:50:31.399 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 02:50:31.377 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 02:50:31.377 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 02:50:31.376 READ FPDMA QUEUED
Error 65 occurred at disk power-on lifetime: 10720 hours (446 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 02:50:28.697 READ FPDMA QUEUED
60 00 20 80 24 d2 45 00 02:50:28.697 READ FPDMA QUEUED
61 00 58 ff ff ff 4f 00 02:50:28.697 WRITE FPDMA QUEUED
61 00 08 ff ff ff 4f 00 02:50:28.696 WRITE FPDMA QUEUED
61 00 08 ff ff ff 4f 00 02:50:28.696 WRITE FPDMA QUEUED
Error 64 occurred at disk power-on lifetime: 10720 hours (446 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 20 ff ff ff 4f 00 02:50:26.198 READ FPDMA QUEUED
60 00 20 ff ff ff 4f 00 02:50:26.155 READ FPDMA QUEUED
60 00 20 ff ff ff 4f 00 02:50:25.588 READ FPDMA QUEUED
60 00 20 ff ff ff 4f 00 02:50:25.575 READ FPDMA QUEUED
60 00 20 ff ff ff 4f 00 02:50:25.573 READ FPDMA QUEUED
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Extended offline Completed: read failure 90% 10842 956697766
# 2 Short offline Completed: read failure 70% 10842 956697766
# 3 Short offline Completed: read failure 70% 10842 956697766
# 4 Extended offline Interrupted (host reset) 00% 383 -
# 5 Short offline Completed without error 00% 263 -
# 6 Extended offline Completed without error 00% 53 -
# 7 Short offline Completed without error 00% 50 -
# 8 Short offline Completed without error 00% 1 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
